CPU MODULE

MP32A Rev.D Module

Features

  • CPU speed : ARM Quad Cortex – A53,64-bits NXP i.MX8Plus, 4 x core  900 – 1800 MHZ
  • CPU RAM   : 1- 8GBRAM LPDDR4, eMMC Flash:8-64GB, NVRAM/FRAM: 128KB,
    Micro SD Card Flash disc – removable
  • Interface    :  LAN: 2×10/100/1000Mbps RJ45, 1 x USB comm. with M8 connector
MP32A Rev.D

MP32A Rev.A Module

Features

  • CPU Speed :  ARM Cortex – A7, 32-Bits Freescale i.MX6, 200-900 MHz 
  • CPU RAM : 128-256MB SDRAM, NAND Flash: 128MB, NVRAM/FRAM: 128KB,
    Micro SD Card Flash disc – removable
  • Interface    :  LAN: 2×10/100Mbps RJ45, 1 x USB 2.0 Host.
MP32A Rev.A

MP32A Rev.B Module

Features

  • CPU Speed :   ARM Cortex – A7, 32-Bits Freescale i.MX6, 200-900 MHz
  • CPU RAM : 128-256MB SDRAM, NAND Flash: 128MB, NVRAM/FRAM: 128KB,
    Micro SD Card Flash disc – removable  
  • Interface    :  LAN: 2×10/100Mbps RJ45, 1 x USB comm with M8 connector
MP32A Rev.B

MP32A Rev.C Module

Features

  • CPU Speed :  ARM Cortex – A7, 32-Bits Freescale i.MX6, 200-900 MHz
  • CPU RAM : 128-256MB SDRAM, NAND Flash: 128MB, NVRAM/FRAM: 128KB,
    Micro SD Card Flash disc – removable
  • Interface : LAN: 2×10/100Mbps RJ45, 1 x serial port(RS232/RS485) with M8 connector
MP32A Rev.C

Adding IO modules in Brodersen Worksuite

Introduction to LB2 I/O Series

The Brodersen LB2 I/O modules are designed for the RTU32M & RTU32N series. The I/O modules are in two parts, a bottom part containing the backplane bus, and a top part containing the I/O board and logic. All LB2 modules are hot swappable and equipped with a 200 MHz processor to process I/O, handle filtering, SOE, debounce, module clock and general module logic. Diagnostic variables are available for all LB2 I/O modules. Please see the module datasheets for full info.

Module firmware update is handled at the RTU level from the Brodersen WorkSuite.

Use only genuine Brodersen bus cables for connection to Brodersen RTUs and for extension of I/O module blocks. The connection cables for the LB2 backplane bus are designed to meet the power requirements and shielding to run high speed communications. The maximum overall length of a complete system is 40 meters. Each LB2 I/O module & power supply module is calculated as 2 cm. The cables are as the length indicates, e.g. UCC-610/1 count as 100 cm.

The maximum system configuration is 60 I/O modules on one LB2 Bus. If the configuration exceeds 60 I/O modules, an additional CPU is required.