Module-PS96A
3d model
50-150 VDC Power Supply Module
PS96A Power supply with a 200 MHz CPU to monitor: Temperature, Voltage in, Voltage out, How much in % is the PS loaded, total uptime hours, Amount of restarts, and many more. They are all available in variables for your SCADA/DCS or for your tablet/Smarty Phone. Support Hot Swap & Redundancy.
In redundancy it is Load Sharing
Two or more Power Supplies can be inserted next to each other, to provide power supply redundancy. The two power supplies will do simple load sharing. If the total load is 100%, one PSU will deliver e.g. 50%, and the second 50%.
If more than 100% (1.2 A) is needed, a new power supply segment is needed.
Module Input power -
Input supply voltage
50..150 VDC ( Vin )
Input Power Consumption
24W ±%5
Module Output power -
Output voltage
12 VDC +- 10% for I/O modules and electronics
Output voltage
max 1.2 A continuous for I/O modules
max 1.6 A overload current limit / short circuit protection
In case of an overload or short circuit, module will turn off and retry after approximately 10 ms.
Module input voltage, current, and output voltage, current is monitored by CPU, and reported to RTU at regular intervals
Ambient Temperature range -
Operating
-20°C to +75°C
Storage
-40°C to +85°C
Power supply redundancy -
Two or more power supplies can be inserted next to each other, to provide power supply redundancy. The two power supplies will do simple load sharing. If the total load is 100%, one PSU will deliver e.g. 60%, and the second 40%.
Note: This is for redundancy only. If more than 100% (1.2 A) is needed, a new power supply segment is needed.
Video Preview
Customers in different industries that use our IO modules.