Module-UCM95
SPECIFICATIONs
Hardware and I/Os:
ADSL Port
RJ11, ADSL/ADSL2/ADSL2+
LAN (Ethernet) Port
RJ45, 10/100 Mbit/s full/half duplex auto sense
Power Supply
Pins 1-3 of 5-pin pluggable terminal block, 24VDC
RST Input
Pins 4-5 of 5-pin pluggable terminal block, to reset or remote on/off
On/Off button
To switch modem on/off
Reset button
Reset to default configuration
LED Indicators
POWER, ON, ETHERNET, DSL, INTERNET
Power Supply
Nominal input voltage
24VDC
Absolute maximum input range
20-35VDC
Input frequency
DC
Power consumption
3W (Typ.)
Isolation
1000 VDC
Environmental
Operating temperature
0°C to 50°C
Storage temperature
-20°C to 60°C
Humidity
20% to 90% RH (Non-condensing)
LED Indicators
POWER (front side)
Indicating input power
ON (left side)
Indicating modem On/Off and Ready/Fault status
ETHERNET (left side)
Indicate LAN connection status
DSL (left side)
Indicating DSL line status
INTERNET (left side)
Indicating Internet status
General
Protection
IP20
Mounting
DIN rail
Housing
Black corrosion protected aluminium housing
Dimensions (WxHxD)
44mmx95mmx93mm
Weight
0,5kg (Approx.)
SYSTEM SPECIFICATIONS
ADSL Compliance
- Support multi-mode standard (ANSI T1.413, Issue 2; G.dmt (G.992.1); G.lite (G992.2))
- EOC specified in ITU-T G.992.1
- ADSL2 G.dmt.bis (G.992.3)
- ADSL2 G.lite.bis (G.992.4)
- ADSL2+ (G.992.5)
- Reach Extended ADSL (RE ADSL)
ATM Protocol
- ADSL physical connection ATM AAL5 (ATM Adaptation Layer Type 5)
- Support multi-protocol over AAL5 (RFC1483/2684)
- Support VC-based and LLC-based multiplexing
- Support up to 8 PVCs
- Support PPP over ATM AAL5 (RFC2364)
- PPP over Ethernet support for DSL connection (RFC 2516)
- 610 F4/F5 OAM loop-back
Network Protocols
- IP routing
- 1d transparent bridging
- IGMP v1&v2
- RIP-1/RIP-2
- ICMP
- TCP/UDP
- DHCP client/server/relay
- DNS proxy
- Dynamic DNS
- UPnP support
- NAT
Management
- FTP for firmware and configuration
- Configuration backup/restore
- Remote management control: Telnet, FTP, and WebUI
- SNMP support
- TR-069 compliance