MODULE-SFP02A
SFP02A
Introduction
The SFP02A is a high-performance, 2-port communication module featuring 2 x 100 Mbps SFP ports, offering plug-and-play operation and the flexibility to support various SFP transceivers. The module is managed and configured via the RTU web server.
This module offers flexibility by supporting both fiber optic and RJ45 copper connections using Brodersen transceivers such as the BS-MM311G-02l, BS-SM311G-10l, BS-MM851G-S5l, or the BP-01-Tl copper interface . To ensure a correct setup, use our online configurator, it automatically calculates the specific power consumption and required backplanes for your configuration. We also offer helpful how-to videos that explain how to use the module, set up drivers, and get started with confidence.
3d model
communication module
2 x 100 Mbps SFP Ports
The module is plug & Play and support Hot – Swap.
Easy to configure within the worksuite software studio
2 x 100Mbps SFP slots
Fiber Optic or RJ45 Copper (SFP-dependent)
Connector type
SFP slot
Typical Distance
SFP Transceiver Specification
Fiber Optic SFP Transceiver Specification
Ordering Code
SFP02A
Introduction to LB2 I/O Series
The Brodersen LB2 I/O modules are designed for the RTU32M & RTU32N series. The I/O modules are in two parts, a bottom part containing the backplane bus, and a top part containing the I/O board and logic. All LB2 modules are hot swappable and equipped with a 200 MHz processor to process I/O, handle filtering, SOE, debounce, module clock and general module logic. Diagnostic variables are available for all LB2 I/O modules. Please see the module datasheets for full info.
Module firmware update is handled at the RTU level from the Brodersen WorkSuite.
Use only genuine Brodersen bus cables for connection to Brodersen RTUs and for extension of I/O module blocks. The connection cables for the LB2 backplane bus are designed to meet the power requirements and shielding to run high speed communications. The maximum overall length of a complete system is 40 meters. Each LB2 I/O module & power supply module is calculated as 2 cm. The cables are as the length indicates, e.g. UCC-610/1 count as 100 cm.
The maximum system configuration is 60 I/O modules on one LB2 Bus. If the configuration exceeds 60 I/O modules, an additional CPU is required.