Multi mode optical fiber communication module with 2 x Ports
The module is plug & Play and support Hot – Swap
Easy to configure within the worksuite software studio
Ports: 2 x 100Base-FX
Connector type: ST (1 X 9)
Typical Distance: 2Km
The FP02C module is ideal if you want long distance communication with high speed and no data loss. Try out the online configurator, it will take care of power consumption, needed backplanes, basically it will hold your hand from end to end. We also have super training videos, that will explain how to use the module, setup drivers and give inspiration.
Introduction to LB2 I/O Series
The Brodersen LB2 I/O modules are designed for the RTU32M & RTU32N series. The I/O modules are in two parts, a bottom part containing the backplane bus, and a top part containing the I/O board and logic. All LB2 modules are hot swappable and equipped with a 200 MHz processor to process I/O, handle filtering, SOE, debounce, module clock and general module logic. Diagnostic variables are available for all LB2 I/O modules. Please see the module datasheets for full info.
Module firmware update is handled at the RTU level from the Brodersen WorkSuite.
Use only genuine Brodersen bus cables for connection to Brodersen RTUs and for extension of I/O module blocks. The connection cables for the LB2 backplane bus are designed to meet the power requirements and shielding to run high speed communications. The maximum overall length of a complete system is 30 meters. Each LB2 I/O module & power supply module is calculated as 2 cm. The cables are as the length indicates, e.g. UCC-610/1 count as 100 cm.
The maximum system configuration is 60 I/O modules on one LB2 Bus. If the configuration exceeds 60 I/O modules, an additional CPU is required.