MODULE-CA02A
CA02A
Introduction
The CA02A is a high-performance, two-port communication module featuring two independent CAN BUS channels, designed for reliable and stable data exchange in industrial automation and control systems. Each channel is accessed via a dedicated 6-pin connector providing CAN High (H) and CAN Low (L) signals. This module can optionally use onboard 59Ω termination resistors or external 120Ω bus termination, providing optimal signal integrity across diverse network topologies.
The CA02A features a comprehensive LED interface including a dual-color status LED and four dedicated LEDs for RX/TX communication status.
The module is configured and managed through the Worksuite software environment, ensuring seamless integration with RTU32M series products. To ensure a correct setup, Try out the online configurator, it will take care of power consumption, needed backplanes, basically it will hold your hand from end to end.
3d model
communication module
2 x CAN BUS Ports
Interface
2 x CAN BUS ports
Connector type
2 x 6-Pins Connector for CAN Bus
Module Status
1 x Dual – color LED for status indication
Data Indicators
4 x LED on front of the module for RX, TX status
Ordering Code
CA02A
Introduction to LB2 I/O Series
The Brodersen LB2 I/O modules are designed for the RTU32M & RTU32N series. The I/O modules are in two parts, a bottom part containing the backplane bus, and a top part containing the I/O board and logic. All LB2 modules are hot swappable and equipped with a 200 MHz processor to process I/O, handle filtering, SOE, debounce, module clock and general module logic. Diagnostic variables are available for all LB2 I/O modules. Please see the module datasheets for full info.
Module firmware update is handled at the RTU level from the Brodersen WorkSuite.
Use only genuine Brodersen bus cables for connection to Brodersen RTUs and for extension of I/O module blocks. The connection cables for the LB2 backplane bus are designed to meet the power requirements and shielding to run high speed communications. The maximum overall length of a complete system is 40 meters. Each LB2 I/O module & power supply module is calculated as 2 cm. The cables are as the length indicates, e.g. UCC-610/1 count as 100 cm.
The maximum system configuration is 60 I/O modules on one LB2 Bus. If the configuration exceeds 60 I/O modules, an additional CPU is required.